Product Description

Locking Collar Included

Mini Collets – For bore diameter from .065″ – .250″
Part #Legacy #DiameterXLengthMini Master (Incl. Locking Collar)SleeveRod Assembly (Includes Screw)Replacement Screw
RPMC40MC-407/16″X1/4″MM-2SL2 – 5CRA10 – 5CES-10
RPMC40XLMC-40XL7/16″X9/16″
RPMC40XXLMC-40XXL7/16″X3/4″
CART mini collet
  1. Clean taper of Mini Master and inside taper of Sleeve and drive Mini Master securely into Sleeve.
  2. Insert Rod Assembly through rear of Sleeve into Mini Master.
  3. Insert Expanding Screw through front of Mini Master into Rod Assembly and bottom screw into Threaded Rod. Hand tighten only until Step 5.
  4. Loosen Lock Nut and adjust Collet Nut so Rod Assembly will travel approximately 1/8″ to 3/16″
  5. Tighten Lock Nut and tighten Expanding Screw securely so neither will loosen itself. Be sure to t ighten Lock Nut first and then the Expanding Screw.
  6. Slide Mini Collet over Mini Master. Line up slots on Mini Collet with those of Mini Master and lock tight with Locking Collar.
  7. Insert assembled unit into machine. Adjust Collet closer until Collet expands slightly and machine to desired size. Chucking length ordinarily should not be turned back more than 1½ times its diameter.
  8. To disassemble, remove Locking Collar, slide Mini Collet off Mini Master. Loosen Expanding Screw entirely, rear of Rod Assembly will then come out. To separate Sleeve from Mini Master insert snug fitting metal rod into rear of Sleeve and give a good smack with a hard hammer. Or, we suggest using the ROVI Collet Separator. Mini Master and Sleeve should separate readily.
  9. We suggest that use use the Rovi Turning Ring when machining the collet to your desired diameter. This encapsulates the collet so that it will not over expand.
Turning Ring (Pack of 5) image 1

Add To Cart

Scoll Down For Product Description

5C Mini Master MM-2

$99.50

Availability: In stock

Product Images

You may also like…

  • Add to cart Quick View
Shopping Cart
Scroll to Top